The Blood Moon Slider — Premium Model

The Blood Moon. Limited to 50 units.

Each unit is tested adequately and put through quality assurance to ensure consistency across products prior to shipping.

Specs:
Size – 50  × 32 mm. Height is 18.4 mm with top plates depressed.

Weight – Approximately 38.4 grams.

Housing – White, black, and red PLA+. Magnet strength has been dialed in for this surface and provides the perfect balance between slide/stick.

Magnet Setup - Magnets are arranged in a 4 x 2 setup with each corner containing a larger/stronger magnet (ideal for tricking). There are two open magnet slots on the top and bottom should you choose to add more. These slots are for 6 x 3 mm magnets.

Haptic Plate - The top of each side has a plate that can be pressed as a button for additional fidget functionality. This plate is sprung up by magnet repulsion and will not wear like springs do.

3D Print Notice - Each slider is 3D printed with 50-100% infill, making it solid and durable. Due to the nature of 3D printing, small cosmetic imperfections may be present. Minor surface flaws are not grounds for return or refund.

Please avoid leaving sliders in direct sunlight or high temperature environments (e.g., inside cars) as product may warp.

Customization Disclaimer:
Swapping magnets is possible, but generally not recommended as the threads for the screws are 3D printed and may not hold up after repeated screwing/unscrewing. If preference is to adjust, just be sure to take it slow and don't overtighten or threads will strip. Fidget Doc is not responsible for any damage incurred as a result of disassembly.

Safety Standards:
Our products comply with safety guidelines, ensuring magnet strength does not exceed the flux limit of 50 kG² mm² and pose no choking hazards with proper use. Not suitable for children under the age of 12.